برد آردوینو Arduino Galileo
در برد آردوینو Arduino Galileo از میکروکنترلر Intel® Quark SoC X1000 استفاده شده است
- Ethernet Port: 10/100 Ethernet connector
- (RS-232 Serial Port: 3-pin 3.5mm jack (not audio
- RS-232: RS-232 transceiver
- (USB 2.0 Client: USB Client connector (Micro-USB Type B
- (USB 2.0 Host: USB 2.0 Host connector (Micro-USB Type AB
- SPI Flash: 8 MByte Legacy SPI Flash to store the firmware (or bootloader) and the latest sketch
- SPI Flash Program Port: 7-pin header for Serial Peripheral Interface (SPI) programming
- Shield Interface: Complies with Arduino Uno Revision 3 shield pinout
- ADC: Analog to Digital converter
- Intel® Quark SoC X1000: 400 MHz 32-bit Intel® Pentium processor
- ICSP: 6-pin in-circuit serial programming (ICSP) header
- 256 MB DDR3 RAM: 256 MByte DRAM, enabled by the firmware by default
- Arduino Interface: Complies with Arduino Uno Revision 3 pinout
- JTAG Debug Port: 10-pin standard JTAG header for debugging
- GPIO Expander: GPIO pulse width modulation provided by a single I2C I/O expander
- (Micro SD slot: Supports micro SD card up to 32 GBytes (Optional
- 5V Power: The board is powered via an AC-to-DC adapter
- Voltage Regulator: Generates 3.3 volt supply
- Eth PHY: Ethernet Physical layer transceiver
تاکنون هیچ نظری ثبت نشده است.
برای ثبت نظر وارد حساب کاربری خود شوید.